Agilent Technologies G2570A GC/MSD Installation And Operation Differences page 61

Operational differences between the G2570A GC/MSD system and a 6890 Plus GC/
5973N diffusion pump system are affected by the following hardware differences:
• The mounting of the column cage onto the oven door significantly alters column
• The control of the GC oven temperature and GC/MSD interface temperature
• The control of all GC parameters (including GC/MSD interface temperature)
• The communication between GC and MSD only by an APG start/stop cable
• Only the split/splitless inlet is supported.
• Means for introducing samples into the split/splitless inlet other than by manual
• No other detectors (including no second GC/MSD) are supported.
• The GC ChemStation software is not supported on the G2570A data system.
Important You must become comfortable using the G2629A GC control module, especially
entering values in screen fields and navigating through and between screens. See
Appendix A for a summary of control module screens.
installation procedures.
locally by the GC Control Module modifies MSD pumpdown and venting
procedures.
locally by the GC Control Module changes how method and sequence
parameters are edited.
changes how methods and sequences are run.
injection or autoinjection (G2613A) are not supported
3 Operational Differences
Introduction
61