Table of Contents
Advertisement
After initiating the method on the MSD ChemStation, data acquisition after a
manual injection can be started by:
• Pressing
on the GC keypad, or
Start
• Pressing the
key (F8) in the Status screen of the GC Control Module.
START
If Auto Prep Run is not enabled in the method, it may be necessary to select
in the GC keypad to set the GC to the Ready condition.
Run
Data acquisition can be stopped before the end of the method by:
• Pressing
on the GC keypad, or
Stop
• Pressing the
key (F7) in the Status screen of the GC Control Module.
STOP
When data acquisition is stopped before the end of the run, the MSD ChemStation
will save the data file.
3 Operational Differences
Manual injection
Prep
79
Advertisement
Table of Contents
