Table of Contents
Advertisement
© Copyright 2000, Agilent
Technologies Company
All Rights Reserved.
Reproduction, adaptation, or
translation without prior
written permission is
prohibited, except as allowed
under the copyright laws.
Microsoft® and WindowsNT ®
are registered trademarks of
Microsoft Corporation.
Document History
Publication number
G2589-90008
First edition, 1/00
Printed in USA
Warranty
The information contained in
this document is subject to
change without notice.
Agilent Technologies makes no
warranty of any kind with
regard to this material,
including, but not limited to,
the implied warranties of
merchantability and fitness for
a particular purpose.
Agilent Technologies shall not
be liable for errors contained
herein or for incidental or
consequential damages in
connection with the
furnishing, performance, or
use of this material.
Agilent Technologies assumes
no responsibility for the use or
reliability of its software on
equipment that is not
furnished by Agilent
Technologies.
Noise Declaration
Deutsch
LpA << 70 dB am Arbeitsplatz
normaler Betrieb nach EN
27779:1991
English
LpA << 70 dB operator
position normal operation per
ISO 7779:1988
System Identification
Each of the following main
components in the G2570A
GC/MSD system is identified
by a unique 10-character serial
number:
MSD-Ready 6850A GC
Right side of the unit, lower
left corner
G2629A Control Module
Back side of the unit, near
center
G2577A Diffusion Pump MSD
Left side of the unit, lower
right corner
Computer
Varies per model
Computer Monitor
Back side of the unit, near
center
G1701CA MSD Productivity
software
Registration number in
Software Certificate and
Registration Packet
Manual Conventions
Cautions
Cautions call attention to
procedures which, if not
correctly performed or
adhered to, could result in
damage to the instrument.
Warnings
Warnings call attention to
procedures which, if not
correctly performed or
adhered to, could result in
personal injury.
Part Numbers
In this manual, Agilent
Technologies part numbers
are generally listed in
parentheses after the name of
the part. Most part numbers
are either four-digit-by-four-
digit (1234-1234) numbers or
five-digit-by-five-digit (12345-
12345) numbers.
Safety Information
Safety Symbols
(on equipment)
;
Refer to operating
instructions
=
Indicates hazardous
voltage
+
Indicates hot surface
3
Indicates earth
(ground) terminal
Safety class
The 5973N Mass Selective
Detector (MSD) is a Safety
Class I instrument and has
been designed and tested in
accordance with IEC
Publication 1010-1 Safety
Requirements for Electrical
Equipment for Measurement,
Control, and Laboratory Use.
WARNING
Connecting the system to a
power source which is not
equipped with a protective
earth contact creates a shock
hazard for the operator and
can damage the instruments.
Likewise, interrupting the
protective conductor inside or
outside the system or
disconnecting the protective
earth terminal creates a shock
hazard for the operator and
can damage the instruments.
WARNING
Make sure that only fuses with
the required current rating
and of the specified type are
used for replacement. The use
of incorrect or makeshift fuses
or the short-circuiting of fuse
holders creates a shock hazard
for the operator and can
damage the instrument.
WARNING
Any adjustment, maintenance
or repair of the opened
instrument while it is
connected to a power source
should be avoided if possible
and, if required, should be
carried out only by trained
persons who are aware of the
hazards involved.
Safety Information is
continued on the inside of the
back cover.
Advertisement
Table of Contents
