Installation Of The Electronic Module - Festo CPX-F8DE-P Manual

2. Installation
2.3

Installation of the electronic module

Festo P.BE-CPX-F8DE-P-E N en 1610a English
Note
Incorrect handling can cause damage to the electronics
modules.
Never push/pull the electronics module into/out of the
•
interlinking block when powered.
Electronic modules include electrostatically sensitive
devices.
Observe the handling specifications for electrostatically
•
sensitive devices.
Discharge yourself electrostatically before assembling or
•
disassembling modules to protect the modules.
Before the CPX terminal can be extended or converted, it
must first be unscrewed and dismantled. Instructions on this
can be found in the CPX system description.
CPX terminals are supplied from the factory completely fitted.
It may be necessary to fit or remove the connection blocks for
the following reasons:
– Replacement of the connection block
Changing the DIL switch setting è Chapter 2.4, on setting
–
the PROFIsafe address
– replacement of a defective electronics module.
The plugs connected to the connection block may remain
attached whilst dismantling the connection block.
2-9