Set Profisafe Address - Festo CPX-F8DE-P Manual

2. Installation
2.4

Set PROFIsafe address

1
Addressing
example –
PROFIsafe
address 578
2
Decimal value
when set set ON
3
Calculation
example – DIL
switch element 2,
7 and 0 (10)
set ON
Fig. 2/2: 10-bit DIL switch for setting the PROFIsafe address – binary coded
Festo P.BE-CPX-F8DE-P-E N en 1610a English
The input module is controlled by an F-Host via PROFIsafe
and needs a PROFIsafe address for the F-host to identify itself
uniquely. The PROFIsafe address is defined by configuration
software and is set using binary coding on the 10-bit DIL
switch. Both settings must match.
Permitted PROFIsafe addresses: 1 ... 1022
The 10-bit DIL switch is located directly on the electronics
module and can be set while the connection block is not
mounted è Fig. 1/1.
The DIL switch setting is evaluated during the start phase of
the firmware.
1. Set the DIL­switch carefully using a small screwdriver.
2. Switch the input module back on to use a new address.
Information on address allocation by configuration software
can be found in the documentation of the software used.
The PROFIsafe address 0 is preset at the factory.
1 2
1
2
4
8
16
32
64
128
256
512
3
2 + 64 + 512 = 578
2-11