Lx Eos/Era - Zeus Interaction; Commands And Declaration Transfer To Lx Eos/Era - LX Navigation Zeus User Manual

6.2 LX Eos/Era – Zeus interaction
After connection between LX Eos/Era and LX Zeus is
established, both units will start to communicate over the
CAN bus. The connection is established automatically
without any pilot interaction.
6.2.1

Commands and declaration transfer to LX Eos/Era

Every time the system is turned on the following data is
sent to LX Eos/Era:

Pilot data: After initial setup on LX Zeus (also
nd
pilot 2 name in the event of a double seater
configuration)

Recording interval

Other data related to flight recording with
recording (Event repetition...)

Selected task: the task will become declared

Active turn-point file (.cup in TP/TSK/Eos slot)

Active turn-point navigation

Other vario settings
A long press on the EVENT button, will send the event
command to LX Eos/Era. The event command can be
sent also from a second seat.
For more information about LX Eos/Era system, refer to LX Eos/Era manual.
Any change on task will immediately update LX Eos' internal task. As long as on ground (not flying),
the new data will be written into declaration of LX Eos flight recorder. The same will happen with pilot
data. After take-off, the task synchronization will start working but the declaration in the flight
recorder will remain unchanged (IGC rule).
Important!
LX Zeus v4.0.2
78 | P a g e