Performance monitoring
Result:
...................................................................................................................................................................................................
Select
4
and then click
Result:
...................................................................................................................................................................................................
Select the measurement period by clicking either Unidir 15 Min or Unidir 24 hr tab
5
and then enable the counters by marking the Enable Counters check box.
Result:
...................................................................................................................................................................................................
Enable thresholding by marking the Enable Thresholding checkbox.
6
Result:
last saved TR and RTR values from the NE and reports it in each parameter field.
If there is no previously saved TR and RTR values (as for a new termination
point), the system will fill in the default threshold values for those parameters (for
thresholds range, minimum/maximum, and default values, see
...................................................................................................................................................................................................
Select
7
Result:
Active Performance Monitoring Points window gets dynamically updated if they
are opened.
...................................................................................................................................................................................................
Select Performance -> PM Current Measurements.
8
Result:
ITM-CIT is in measurement mode.
...................................................................................................................................................................................................
Click
9
Result:
along with the RTD counters (Frame Delay monitor counters).
E
N D
...................................................................................................................................................................................................
....................................................................................................................................................................................................................................
10-68
The
Performance Monitoring Point Filter
Ethernet Service Route
Ok
.
The
Edit Performance Monitoring Point
The checkbox Enable Counters is enabled.
The threshold crossing functionality is enabled. The systems retrieves the
OK
.
The Edit Performance Monitoring Point Filter window disappears. The
The Select Performance Monitoring Points window is displayed. The
Ok
.
The Current Performance Monitoring Measurement window is displayed
O F
S T E P S
Alcatel-Lucent - Proprietary
RTD PM counters, RDT/TCA support, and End-2-End
for PM Point Type and enter the
See notice on first page
Ethernet PM - RTD
window appears.
Service Route ID
window appears.
"Concepts" (p.
365-312-807R7.2
Issue 4, May 2007
10-3).