Managing The Dcc - Alcatel-Lucent 1643 AMS User's Operation Manual

Management communication setup

Managing the DCC

...................................................................................................................................................................................................................................
When to use
The purpose of this procedure is to change the DCC status in the Regenerator Section
(RS) and Multiplexer Section (MS) of each STM-N port.
Use this procedure to reduce the exchange of routing data between network elements.
Reduction of the exchange of management data is done in order to optimize the Data
Communications Network (DCN). The DCC status can be set to enabled or disabled in
order to achieve this.
Related information
Refer to
Before you begin
Pay attention to the following:
• Disabling DCC can cause permanent loss of association between the management
system (ITMCIT) and the network element. In that case the DCC ports can be
enabled by a local login with the Local Workstation.
• Enabling DCC can cause instability in the Data Communications Network (DCN).
• A data communications network plan must be available.
Procedure
Complete the following procedure to view and change the status of the DCC.
...................................................................................................................................................................................................
Select Management --> Overlay Comms Network --> DCC.
1
Result:
...................................................................................................................................................................................................
Select the port for which the DCC status must be changed and click
2
Result:
...................................................................................................................................................................................................
Select the DCC status for the selected port.
3
Result:
...................................................................................................................................................................................................
Click
4
Result:
message:
WARNING
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
"Concepts" (p. 4-3).
The DCC List window appears.
The Edit DCC window for this port appears.
The required values are selected.
OK
to confirm the current settings.
In case Disabled is selected a pop up window will appear with the
Alcatel-Lucent - Proprietary
See notice on first page
Edit
.
4-41