Alcatel-Lucent 1643 AMS User's Operation Manual page 628

Performance monitoring
WAN, LAN port
A filter that can be applied to identify the WAN or LAN port is monitored for that
point type.
PM point type
Displays a list from which you can select a monitorable and available point on the unit
card. Changing the point type filter will dynamically re-populate the slot and port
combo-boxes, as well as enabling the third field where the layer filter for cross
connections or LAN interconnections must be further defined.
Port VC4
Displays a list of VC4 (VC-4-4c, VC-4-16c) ports available on the selected slot. The
default is greyed out and empty. Displays the selection of VC4s after slot is selected. If
all slots are selected, then all ports VC4 is the only choice possible in this field. The
All value is only possible if the originating screen is Active Performance Monitoring
Points, and not when it is Edit Performance Monitoring Point.
Selected TP
This field is automatically filled with the value of the PM Point Type selected in the
originating Performance Monitoring Point Filter window.
SES
This is an ITU-standard and is defaulted as the maximum number of admissible EB
over one second. The SES Declaration Threshold is the cut-off for ES. If the total
number of EB over one second exceed this value, it is considered to be an SES. For all
network elements, this number of blocks defaults to 30% of the maximum number of
blocks (for example, 2400 for a VC-4; 600 for VC-12).
Slot
Displays a list of (virtual) slots in the system that contain possible monitoring points,
matching the selected PM Point Type. The default is empty and greyed out. A Point
Type must be selected to make selection possible in this field.
TR and RTR
TR stands for Threshold Report and causes a threshold crossing event. The RTR stands
for reset threshold report and causes a resetting of the event. The minimum value for
RTR is 0 and 1 for TR. As a general rule, RTR must be lower than TR. The range of
their possible values varies namely according to the parameters. For more information
on those range values, please refer to the section Concepts.
The ITM-CIT will consider these thresholds provided that the Enable counter and
Enable Thresholding are marked. When Thresholding is enabled, the TR and RTR
values are retrieved from the network element. If the termination point is new (as for a
new termination point), the system assigns the default values.
....................................................................................................................................................................................................................................
10-46 Alcatel-Lucent - Proprietary
See notice on first page
Parameters for configuring PM on the ITM-CIT
365-312-807R7.2
Issue 4, May 2007