Alcatel-Lucent 1643 AMS User's Operation Manual page 647

Performance monitoring
Result:
Traffic Monitor
window.
...................................................................................................................................................................................................
Click
3
Result:
...................................................................................................................................................................................................
Select
4
Port and then click
Result:
...................................................................................................................................................................................................
Select the measurement period by clicking either Unidir 15 Min or Unidir 24 hr tab
5
and then enable the counters by marking the Enable Counters check box.
Select the User Provisionable LS/SLS by clicking the PM Attribute tab and then
the Nominal Data Rate and the LS/SLS estimator should be provisioned.
Result:
The
...................................................................................................................................................................................................
Enable thresholding by marking the Enable Thresholding checkbox.
6
Result:
last saved TR and RTR values from the NE and reports it in each parameter field.
If there is no previously saved TR and RTR values (as for a new termination
point), the system will fill in the default threshold values for those parameters (for
thresholds range, minimum/maximum, and default values, see
The Enable Thresholding box is not available for Ethernet Low Priority Traffic
monitor.
...................................................................................................................................................................................................
Select
7
Result:
Active Performance Monitoring Points window gets dynamically updated if they
are opened.
...................................................................................................................................................................................................
Select Performance -> PM Current Measurements.
8
Result:
ITM-CIT is in measurement mode.
...................................................................................................................................................................................................
Click
9
....................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
The
Ethernet High Priority Traffic Monitor
is enabled in the
Add
.
The Performance Monitoring Point Filter
Ethernet HQ Traffic
Ok
.
The Edit Performance Monitoring Point
The checkbox Enable Counters is enabled.
PM attribute tab is not available for the Ethernet Low Priority Traffic monitor.
The threshold crossing functionality is enabled. The systems retrieves the
OK
.
The Edit Performance Monitoring Point Filter window disappears. The
The Select Performance Monitoring Points window is displayed. The
Ok
.
Alcatel-Lucent - Proprietary
Ethernet High Priority, Low Priority Traffic Monitor and
Active Performance Monitoring Point List
or Ethernet LQ Traffic
See notice on first page
User Provisionable LS/SLS Threshold
or the
Ethernet Low Priority
window appears.
for PM Point Type and select the
window appears.
"Concepts" (p. 10-3).
10-65