The Performance Monitoring Process - Alcatel-Lucent 1643 AMS User's Operation Manual

Performance monitoring

The performance monitoring process

...................................................................................................................................................................................................................................
Process description
The performance monitoring process is a three-stage process:
Primary
processing
Primary processing
Fundamental parameters are derived from errors detected in the transport signal,
classified into bit errors and defects, and accumulated over one-second periods.
Parameter processing
Near-end and far-end performance parameters are calculated based on the evaluation
and correlation of the fundamental parameters obtained during the primary processing.
Please refer to
Binning and reporting
In the binning and reporting phase, the performance parameters obtained during the
parameter processing are stored in accumulation registers (or "bins") over 15-minutes
and 24-hours observation periods.
For each performance monitoring point (cf.
recent (or history) bins for 15-minutes measurements and one recent bin for 24-hours
measurements are stored in the NE.
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Parameter
processing
"Available PM data" (p.
Alcatel-Lucent - Proprietary
See notice on first page
Multiplex
Section, Line
Binning
Regenerator
and
Section, Section
reporting
Path
(path termination,
path monitoring)
10-27).
"Performance measurements" (p. 10-8)), 16
10-7