Creating A Node - Alcatel-Lucent 1643 AMS User's Operation Manual

Equipment provisioning

Creating a node

...................................................................................................................................................................................................................................
When to use
A node should be created when a new network element is available to be placed into
service.
Related information
The related procedure is:
• Provision Units
• Confirm the MIB.
Before you begin
Before starting to create a node determine the following:
• the name, address, and location of the node are known.
• the location and type of units physically present in the NE are known.
• the main unit must be assigned before the interfaces associated with this unit can
be assigned. For example, a tributary port unit must be assigned before the ports
for this unit can be assigned.
• For the 1643 AM and 1643 AMS, the only slot which may be user assigned is TS2.
Any mistake in provisioning the slots will result in a failure when attempting to
create the node. When a mistake has been made, after clicking
message "Slot configuration conflict" appears. The node creation has failed, and the
entire node creation process must be begun a new.
• To create an association with the ITM-SC, the network element cannot be in an
isolated state. (As a default condition, the 1643 AM or 1643 AMS arrives from the
factory in an isolated state.) To view if the network element is in the isolated state,
select Management -> Overlay Comms Network -> DCN. Should the network
element be in an isolated state, click
Information then appears. In this window, change (or reselect) any of the displayed
parameters and click
association with the ITM-SC will now be possible.
Procedure
Follow these steps to create a network element.
...................................................................................................................................................................................................
Select Management -> Node Creation.
1
Result:
...................................................................................................................................................................................................
Enter the NE Name and NE Location.
2
...................................................................................................................................................................................................................................
5-16
OK
. Doing so will remove the NE from isolation and
The Node Creation - Parameters window appears.
Alcatel-Lucent - Proprietary
See notice on first page
Edit
. The window Edit Provisioned DCN
Finish
, the error
365-312-807R7.2
Issue 4, May 2007