Editing Pm Counter Thresholds - Alcatel-Lucent 1643 AMS User's Operation Manual

Performance monitoring

Editing PM counter thresholds

...................................................................................................................................................................................................................................
When to Use
The following procedures must be performed when you want to enable performance
monitoring on a termination point, to set the threshold values and the granularity of the
monitored period.
Related Information
The items below list other relevant information to this procedure:
• Procedure to set the SDH TP Mode, for the required prior setting of the ports to be
monitored. Refer to
•
"Concepts" (p. 10-3)
Parameters used in this procedure can be found at
the ITM-CIT" (p.
Before you begin
In order to be able to enter values in the various threshold fields, you must:
• Enable the Enable Thresholding checkbox
Edit PM counter thresholds
Follow this procedure in order to modify the values of the counter thresholds
...................................................................................................................................................................................................
Select Performance -> PM TP Configuration.
1
Result:
Configuration mode.
...................................................................................................................................................................................................
Select a filter from the proposed lists, for each enabled field.
2
Result:
PM point type selected.
...................................................................................................................................................................................................
Select
3
Result:
Performance Monitoring Point window appears.
...................................................................................................................................................................................................
Select a binning period tab and verify that the Enable Thresholding checkbox is
4
marked.
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
"Provision ports" (p.
10-45).
The PM Point Filter window is displayed. The ITM-CIT is in PM
The Slot, Port and AU4 fields dynamically get enabled according to the
OK
to apply the selection.
The Performance Monitoring Point Filter window disappears. The Edit
Alcatel-Lucent - Proprietary
5-59).
See notice on first page
"Parameters for configuring PM on
10-43