Table of Contents
Advertisement
Installing the Switch on a Concrete Wall
This section contains the instructions for installing the switch on a concrete
wall. Please review the information in the following sections before
performing the procedure:
"Switch Orientations on a Wall" on page 78
"Installation Guidelines" on page 79
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
Warning
The device should be installed on the wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if it is not properly fastened to the wall.
E105
To install the switch on a concrete wall, perform the following procedure:
1. Place the switch in a table.
2. For the AT-x550-18XTQ or AT-x550-18XSQ Switch, install the four
AT-BRKT-J24 wall brackets to the sides of the unit, with the sixteen
M4x6mm screws included with the switch. Refer to Figure 43 on page
84.
3. For the AT-x550-18XSPQm Switch, install the two wall/equipment rack
brackets to the sides of the unit with the eight M4x6mm screws
included with the switch. The brackets should be installed diagonally
across from each other. Refer to Figure 44 on page 85.
4. Have another people hold the switch on the concrete wall at the
selected location for the device while you use a pencil or pen to mark
the wall with the locations of the four screw holes in the four brackets
(one screw per bracket). Refer to Figure 46 on page 88.
Please follow these guidelines as you position the switch on the wall:
Position the switch so that the front panel is either on the left or the
right. Refer to Figure 40 on page 78. You may not install the switch
with the front panel facing up or down.
Leave sufficient space from other devices or walls so that you can
access the front and back panels, and for adequate air ventilation.
x550 Series Installation Guide for Stand-alone Switches
87
Advertisement
Table of Contents
