Table of Contents
Advertisement
Chapter 1: Overview
eco-friendly Button
38
The eco-friendly button on the front panel of the switch is used to toggle
the port LEDs on or off. You can turn off the LEDs to conserve electricity
when you are not monitoring the device. You can also toggle the LEDs
with the ECOFRIENDLY LED and NO ECOFRIENDLY LED commands in
the Global Configuration mode of the command line interface of the
AlliedWare Plus management software.
The switch is operating in a low power mode when the LEDs are turned
off. Operating the switch in the low power mode does not interfere with the
network operations of the device.
The management software on the switch has a command that blinks the
LEDs so that you can quickly and easily identify a specific unit among the
devices in an equipment rack. It is the FINDME command. The command
works on the switch even if you turned off the LEDs with the eco-friendly
button or NO ECOFRIENDLY LED command.
The Switch ID LED is always on, but it displays different information
depending on whether the LEDs are on or off. When the LEDs are on, the
ID LED displays the ID number of the switch. When the switch is operating
in the low power mode with the LEDs off, the ID LED indicates whether the
switch is a stand-alone unit or the master or member switch of a VCStack,
as detailed in Figure 12 on page 41.
Note
Before checking or troubleshooting the network connections to the
ports on the switch, you should always check to be sure that the
LEDs are on by either pressing the eco-friendly button or issuing the
ECOFRIENDLY LED and NO ECOFRIENDLY LED commands in
the Global Configuration mode in the command line interface.
Advertisement
Table of Contents
