1Gbps/10Gbps Twisted Pair Ports On The At-X550-18Xtq Switch; Cable Requirements; Table 2: Twisted Pair Ports On The At-X550-18Xtq Switch; Table 3: Cable Requirements For The 1Gbps/10Gbps Twisted Pair Ports On The At-X550-18Xtq Switch - Allied Telesis x550 Series Installation Manual

Chapter 1: Overview

1Gbps/10Gbps Twisted Pair Ports on the AT-x550-18XTQ Switch

Cable
Requirements
22
The specifications of the sixteen twisted pair ports on the AT-x550-18XTQ
Switch are listed in Table 2.
Table 2. Twisted Pair Ports on the AT-x550-18XTQ Switch
Specification
Port Speed
Duplex Mode
Maximum Distance
Connector
Note
The ports must be set to Auto-Negotiation to function at 1Gbps. The
network devices connected to the ports must be IEEE 802.3u
compliant.
The cable requirements for the ports are listed in Table 3.
Table 3. Cable Requirements for the 1Gbps/10Gbps Twisted Pair Ports
Cable Type
Standard TIA/EIA 568-B-compliant
Category 3 shielded or unshielded
cabling with 100 ohm impedance and a
frequency of 16 MHz.
Standard TIA/EIA 568-A-compliant
Category 5 shielded or unshielded
cabling with 100 ohm impedance and a
frequency of 100 MHz.
Standard TIA/EIA 568-B-compliant
Enhanced Category 5 (Cat 5e) shielded
or unshielded cabling with 100 ohm
impedance and a frequency of 100 MHz.
1Gbps or 10Gbps
You can set port speed with Auto-
Negotiation or manually. The default is
Auto-Negotiation.
Full-duplex only
100 meters (328 feet)
8-pin RJ-45
on the AT-x550-18XTQ Switch
Description
1Gbps 10Gbps
No No
No No
Yes No