Installing The Switch; Figure 24: Switch Orientations With The Rear Panel Facing The Front Of The Equipment Rack - Allied Telesis x550 Series Installation Manual

You can also orient the switch with the rear panel facing the front of the
equipment rack. Refer to Figure 24.
Figure 24. Switch Orientations with the Rear Panel Facing the Front of the
Installing the
If you have not chosen an orientation for the switch in the equipment rack,
review "Switch Orientations in the Equipment Rack" on page 63.
Switch
Please review the installation guidelines in "Choosing a Site for the Switch"
on page 52 before installing the switch in an equipment rack.
To install the switch in a 19-inch equipment rack with the AT-RKMT-J14
Brackets, perform the following procedure:
1. Attach the two handles to the AT-RKMT-J14 Brackets using the four
Caution
The chassis may be heavy and awkward to lift. Allied Telesis
recommends that you get assistance when mounting the chassis in
an equipment rack.  E28
M3x6mm screws included with the switch. Refer to Figure 25 on page
66.
x550 Series Installation Guide for Stand-alone Switches
Equipment Rack
65