CR 30-X S
YSTEM
Main System Configuration
The CR 30-X System has the following configuration:
•
the CR 30-X digitizer, a digitizer for image plates retaining latent X-ray
images. The CR 30-X accepts one cassette containing one image plate at a
time.
•
NX 1.0 or higher. NX is a CR workstation for image acquisition,
identification, image processing and image transmission of digitized
images received from the digitizer.
•
Cassette and plate system: CR MD4.0T General Plate and Cassette.
Optional System Components
Powerware
The main CR 30-X System can be extended with the Powerware
uninterruptible power system (UPS). The UPS is available in two voltage
types: 110 V and 230 V
The Powerware
when the main power supply has crashed, and avoids the loss of images. UPS
configuration requires special software. This software will be installed and
configured by an Agfa service technician.
With the Powerware
disturbances and guard the integrity of your CR 30-X System.
8
Introduction
Note: The application is intended to be used for Genrad only, not for
Mammography nor FLFS (Full Leg Full spine).
®
5115 UPS
®
5115 uninterruptible power system (UPS) protects the PC
®
5115, you can safely eliminate the effects of power
®
5115
2385A EN 20060630