Instructions; Figure 3-26 Enc82L-Environmental Enclosure Sample Boot - ABB NGC8206 User Manual

3.15.2 Instructions

1) Locate the sample input fitting on sample conditioning module (see
2) Locate the sample boot on side of environmental enclosure. Sample lines must
feed through the sample boot located on the side of the enclosure.
3) Measure and cut SST tubing to required length. Feed sample tubing through
sample boot.
Figure 3-26 ENC82L–Environmental Enclosure Sample Boot
Page 3–26
Be certain that the ends of stainless steel tubing are open and
not restricted.
3-26) and sample output fitting on installed sample probe..
Sample Boot
Figure
2101510 Rev. AG