Instructions - ABB NGC8206 User Manual

3.30.1 Instructions

1) If configured, the optional equipment unit should contain an installed power
2) Remove the necessary plugs from the side of the enclosure to install the rigid
conduit.
3) Pipe the conduit and associated AC wiring into the enclosure.
4) Using wiring instructions in
VAC hot and neutral or the two hot wires for 230 VAC.
5) Pipe the conduit and associated DC wiring from the NGC into the power supply
enclosure. See
6) Remove the J1 connector from the NGC termination panel. Using the wiring
instructions in
as shown to J1 connector (+) pin and connect the ground wire to J1 connector (-)
pin. Do not re-insert the J1 connector to the termination board.
7) Proceed to the
8) Go to
2101510 Rev. AG
supply. The Optional Equipment Enclosure Installation
installed using instructions shown previously in this chapter.
Please review the Grounding the NGC section in,
Description, before making power connections.
Figure
Table 2–4 for wire sizes.
Figure 3-65, make field connections from the power supply wire
Battery Pack Installation
DC Power Installation
3-65, make the field connections from the 115
instructions later in this chapter.
later in this chapter.
should be
System
Page 3–61