Figure 3-51 Temperature Probe Installation - ABB NGC8206 User Manual

8) Place the nut, front ferrule and back ferrule onto the opposite end of the tubing
and position so that the ferrules and nut screw onto the bottom of T assembly.
Screw nut until tight.
9) Remove ferrules and nut from the thermostat end of the thermostat assembly.
Apply Teflon
10) Insert tube end of thermostat assembly through the exterior wall on the side of
the enclosure (see
11) Place the nut, front ferrule and back ferrule onto the end of the 3/8" bent tubing
inside of the enclosure. Position the thermostat assembly so that the nut and
ferrules screw onto the thermostat assembly.
12) Remove the ferrules and nut from end of the regulator assembly closest to the
service cock. Apply Teflon
13) Place the nut, front ferrule and back ferrule onto the end of the thermostat
assembly protruding from the enclosure.
14) Hold the regulator assembly with the curved tubing up, above the protruding
tubing. Screw the ferrules and nut onto the nipple (see
15) Apply Teflon
16) Insert the port one nipple on the filter/drain assembly into the output port on the
regulator and tighten the nut.
17) Gently uncoil the temperature probe capillary tubing from the thermostat and
insert through the hole located below the thermostatic gas valve, being careful to
not crimp or make sharp bends in the capillary tubing (see
18) Remove mounting screw and washers from the right rear NGC mounting bracket
(see
19) Insert the screw with washers still in place through the hole located on the
mounting clip and re-insert through the mounting bracket into the channel nut
(see
20) Position the probe underneath the mounting clip. Tighten the screw into the
channel nut to hold the probe in place.
2101510 Rev. AG
®
tape to threads.
Figure 3-50).
®
®
tape to the port one nipple on the filter/drain assembly.
Figure 3-51).

Figure 3-51 Temperature Probe Installation

Figure 3-51).
tape to threads.
Figure 3-50).
Figure 3-51).
Page 3–49