Small Free-Standing Environmental Enclosure Installation; Materials; Installation; Figure 3-6 Enc82L-Enclosure Mounting Hardware - ABB NGC8206 User Manual

Figure 3-6 ENC82L–Enclosure Mounting Hardware
5) Repeat for all other corners.
6) Position enclosure on stand, centering stand underneath, or offset as desired,
and tighten all bolts.
7) Foot plate mounting holes are pre-drilled for mounting to a pad. Hardware is to
be supplied by the customer.

3.6 Small Free-standing Environmental Enclosure Installation

3.6.1

Materials

•
•
•
•
3.6.2

Installation

1) This stand is not symmetrical. Locate angle iron with slotted holes for floor
2) Set enclosure on top of stand, oriented so that the stand brace is horizontal with
the front of the enclosure (see
3) Place a split washer, then a flat washer on one of the 1 ¼" bolts and insert
through bolt hole located in the angle iron into the outermost corner of the
enclosure (see
2101510 Rev. AG
If the installation includes a small free-standing environmental
enclosure, follow these instructions; otherwise, skip to the
next section.
4 ea. ½-13 x 1 ¼ SST bolt
4 ea. ½ SST flat washer
4 ea. ½" SST split washer
1 ea. stand
anchors and place stand base on a flat, stable, surface.
Figure 3-8).
Figure 3-7).
Page 3–9