Table of Contents
Advertisement
Figure 124:
Using Pack Bits Control Words
Once the Control Word(s) have been configured by the user, they can be utilized by fieldbus communications (i.e. Modbus,
EtherNet I/P, Profibus, DeviceNet, etc.) or within a user program. Figure 88 shows an example in which the user will write to
the Control Word 0 and 1 via Ethernet I/P.
Figure 125:
8.5.11 Pack Bits Status Words View
Status Words work to pass bit-level status information from the drive back to the master device as a 16-bit word(s). The user
configures the Status Word(s) by dragging-and-dropping the desired bit-level parameters they wish to read onto the Status
Word mapping. Figure 89 below shows the Packed Bits Status Words view onto which the user has dragged several status
parameters.
EZMotion User/Programming Guide
Revision A8
Control Word Online Status View
Using Ethernet to Communicate to the Control Words 0 and 1
www.controltechniques.com
115
Advertisement
Table of Contents
