Emerson EZMotion User Manual page 29

assignments, and throughout the software.
Ptools Operation
Selecting Options > Preferences > Ptools Operation allows the user to configure certain settings for the way PowerTools
Pro software functions. Figure 15 shows the Preferences window.
Figure 15:
The PopUps tab is used to configure several options related to downloading files, uploading files, and file saving. Once the
parameters have been set in this window, the user will no longer be prompted with pop-ups when they upload or download
files.
For more information on these options, refer to PowerTools Pro Operation Preferences on page 29 in this manual.
Figure 16:
The Communications tab is used to configure which communication ports are scanned when uploading or downloading. When
the check box is selected that port will be scanned and to disable a port scan clear the check box.
The user can configure which node addresses they wish to poll when uploading, downloading or flash upgrading devices.
PowerTools Pro will not check to see if any devices with node addresses lower or higher than the numbers entered are
available on the network.
The baud rate can also be changed from the default of 19200. Once the settings are configured, click OK.
For more information on these tab, refer to Communications Tab on page 25 in this manual.
Motor DDF
The Motor DDF tab controls which .ddf file PowerTools will use when working with the configuration file.
EZMotion User/Programming Guide
Revision A8
PowerTools Preferences-PopUps Tab
PowerTools Preferences - Communications Tab
www.controltechniques.com
17