Save .Ddf Values Button - Emerson EZMotion User Manual

Servo Mode
Motor Parameter
Continuous Current
Phase Resistance SP
Transient Inductance SP
Max. Operating Speed
Thermal Time Constant
Encoder Phase Angle
In addition to the above list, the user must set the Encoder Type and Encoder Lines Per Rev properly before running the Auto-
Tune procedure.
Closed Loop Vector Mode - SM-EZMotion/Unidrive SP Only
Motor Parameter
Full Load Rated Current
Rated Frequency
Phase Resistance SP
Transient Inductance
Max. Operating Speed
Full Load Rated Speed
Thermal Time Constant
Rated Power Factor
Stator Inductance
Saturation Breakpoint 1
Saturation Breakpoint 2
In addition to the above list, the user must set the Encoder Type and Encoder Lines Per Rev properly before running the Auto-
Tune procedure.
8.2.8

Save .ddf Values Button

Once the user has entered the data for the motor they are using, they may or may not wish to save the motor data to the
SPMotor.ddf file so it can be easily recalled at a later time. If the user does not save the motor data to the SPMotor.ddf file,
then the motor data will only reside in the specific application configuration file that it has been entered into.
In order to save the motor data to the SPMotor.ddf file, the user simply clicks on Save .ddf Values on the Motor Tab. Doing so
will take all the parameter values and write them to the SPMotor.ddf file automatically.
When saving to the .ddf file, if PowerTools Pro finds that a motor already exists with the same name, the User Defined Motor
Name Conflict dialog box shown in Figure 62 will appear. The user must then decide how to proceed with saving the motor
data .ddf file.
EZMotion User/Programming Guide
Revision A8
Needed to Run Auto-Tune
Motor Name
Peak Current
Motor Poles
Rotor Inertia
Motor Ke
Needed to Run Auto-Tune
Motor Name
Peak Current
Rated Voltage
Motor Poles
Rotor Inertia
Motor Kt
www.controltechniques.com
Measured by Auto-Tune Mode #
Yes
Yes
Yes
Yes
Measured by Auto-Tune Mode #
Yes
Yes
Yes
Yes
Yes
Yes
Yes
1, 2
1, 2
2
1, 2
1, 2
2
2
2
2
2
55