Solution Module Compatibility Chart - Emerson EZMotion User Manual

2.4

Solution Module Compatibility Chart

The table below shows what solution modules are compatible with the SM-EZMotion module as well as the firmware revision
and the version of PowerTools software needed to program the combinations.
Module
SM-Resolver
SM-Universal Encoder Plus
SM-Encoder Plus
SM-I/O Plus
SM-I/O Timer
SM-I/O PELV
SM-I/O 24V Protected
SM-I/O 120V
SM-I/O Lite
SM-I/O 32
SM-Applications
SM-Applications Lite
SM-Applications Plus
SM-Profibus DP
SM-Interbus
SM-CAN
SM-DeviceNet
SM-CANopen
SM-SERCOS
SM-Ethernet
SM-SLM
1
- indicates that this module can be used along with SM-EZMotion, but is not directly configured by PowerTools Pro.
Therefore, the user must write a custom program to handle the parameter passing to/from the solutions module.
2
- indicates that support for this module was introduced in earlier rev than indicated, but user is required to use the revision
shown for proper operation.
EZMotion User/Programming Guide
Revision A8
Compatible with Configured by
SM-EZMotion PowerTools Pro
X X
X X
X X
1
X
1
X
1
X
X X
1
X
X X
1
X
1
X
1
X
X X
1
X
1
X
X X
1
X
X X
www.controltechniques.com
PowerTools Pro SM-EZMotion
Rev Required Firmware Rev
Required
3.0 or greater A3 or greater
3.0 or greater A3 or greater
3.0 or greater A3 or greater
Any Any
Any Any
Any Any
3.1 or greater A6 or greater
Any Any
2 2
4.4 or greater B3 or greater
Any Any
Any Any
Any Any
3.2 or greater A8 or greater
Any Any
Any Any
3.2 or greater A8 or greater
Any Any
3.1 or greater A6 or greater
5