Table of Contents
Advertisement
8.3
Slot # View
The Slot # View(s) allow the user to configure which option modules are populated in which slots. Some of the views,
depending on the option module selected, have configuration or setup parameters associated with the module. Each of the
views for the different option modules are shown below. The Unidrive SP has three slots available and the Digitax ST has two
slots. When a new application file is started for the Digitax ST EZMotion drive the EZMotion is automatically set in PowerTools
Pro.
8.3.1
Empty Slot View
If Empty Slot is selected in the Slot# Module list box, the remainder of the view should be blank. The hierarchy tree
automatically updates to show that no module is populated in the specific slot, see Figure 64.
Figure 64:
8.3.2
EZMotion Module View
If EZMotion is selected in the Slot# Module list box, the remainder of the view should be blank. The hierarchy tree
automatically updates to show that an SM-EZMotion module is populated in that specific slot, see Figure 65.
Figure 65:
8.3.3
SM-I/O Plus Module View
If I/O Plus is selected in the Slot# Module list box, the remainder of the view should have configuration parameters for the
modules Digital Inputs and Outputs. The hierarchy tree automatically updates to show that an SM-I/O Plus module is
EZMotion User/Programming Guide
Revision A8
Slot # View (Empty Slot)
Slot # View (SM-EZMotion Module)
www.controltechniques.com
57
Advertisement
Table of Contents
