Manual Start/Stop Operation; Emergency Start - Smartgen HGM400N Series User Manual

4.4 MANUAL START/STOP OPERATION

1) HGM420N: Manual mode is selected by pressing the
illuminate to confirm the operation. In this mode, press
automatically judge crank success and accelerate to high speed running. If high temperature, low oil
pressure, over speed and abnormal voltage occur during genset running, controller can effectively
protect genset to stop (detail procedures please refer to No.4~9 of Auto start sequence). In Manual
Mode, load switch won't auto-switch. It needs to press
mains switch to close/open by pressing
2) HGM410N: Manual mode is selected by pressing the
illuminate to confirm the operation and the genset start. It can automatically judge crank success and
accelerate to high speed running. If high temperature, low oil pressure, over speed and abnormal
voltage occur during genset running, controller can effectively protect genset to stop (detail procedures
please refer to No.4~9 of Auto start sequence). After genset high speed normal running, It needs to
press to enter close/open interface, it controls mains switch to close by pressing
gen switch to open by pressing
3) Manual stop: pressing
of Auto stop sequence)

4.5 EMERGENCY START

In manual mode, pressing
the controller has started successfully according to disconnect conditions and the disconnection of starter
needs to control by operators. When operators observed the genset has started successfully, loose the
keys and the controller enter safety delay with start stops to output.
HGM400N Series Genset Controller
HGM400N Series Genset Controller User Manual
and controls gen switch to close/open by pressing
(gen is on load).
key can stop the running genset. (detail procedures please refer to No.3~7
can compel genset to start. The controller won't judge whether
and
2017-04-21
button; a LED besides the button will
button to start the genset, it can
to enter close/open interface, it controls
button; the LED besides the button will
Version 1.2
.
and controls
Page 10 of 36