Smartgen HGM400N Series User Manual page 20

No Items
30 Low Fuel Level
31 Aux. Sensor
32 Loss of Speed Signal
33 Charge Alt Failure
34 Battery Over Volt
35 Battery Under Volt
36 Current Trans.
Full Load Current
37
Rating
Over Current
38
Percentage
39 Over Current Delay
40 Fuel Pump On
41 Fuel Pump Off
42 Aux. Output 1
43 Aux. Output 2
HGM400N Series Genset Controller
HGM400N Series Genset Controller User Manual
Range Default
(0-100)% 10
(80-140)ºC
(0-400)kPa 98
(0-100)%
(0-20.0)s 5.0
(0-30)V 6.0
(12-40)V 33.0
(4-30)V 8.0
(5-6000)/5 500
(5-6000)A 500
(50-130)% 120
(0-3600)s 30
(0-100)% 25
(0-100)% 80
(0-17) 14
(0-17) 2
2017-04-21
Description
has expired. If the set value is 0, low oil
pressure signal will not be sent (this only
concerns pressure sensor and does not
concern low oil pressure warning signal via
configurable input port)
When the liquid level of the external sensor falls
below the set value, "Low Fuel Level" timer is
initiated. (this only concerns fuel level sensor
and does not concern low fuel level warning
signal via configurable input port)
Each value correspond
(Temperature sensor), 29 (Oil pressure sensor)
and 30 (Level sensor), respectively.
If the set value is 0, only warning and not to
shutdown the generator.
During generator is normal running, when
alternator D+(WL) voltage has fallen below the
set value and remains for 5s, It will initiate a
shutdown alarm signal.
When battery voltage has exceeds the set
value and remains for 20s, It will initiate a
warning alarm signal. Only warning and not to
shutdown the generator.
When battery voltage has fallen below the set
value and remains for 20s, It will initiate a
warning alarm signal. Only warning and not to
shutdown the generator.
The ratio of external CT
Generator's rated current, used for load over
current calculating.
When the load current has exceeded the set
value, "over current" delay is initiated.
When load current has exceeded the set value
and the "over current" delay has expired, over
current alarm is initiated. When the set value is
0, only warning and not to shutdown the
generator.
When fuel level has fallen below the set value
for 10s, "Fuel Pump On" alarm is initiated.
When fuel level has exceeded the set value for
10s, "Fuel Pump Off" alarm is initiated.
Factory default: Fuel Relay Output
Factory default: Energized To Stop
Version 1.2
to above 28
Page 20 of 36