Smartgen HGM400N Series User Manual page 13

23 Gen Under Volt
24 Gen Over Freq
25 Gen Under Freq
26 Fail to Charge
27 Over Power
HGM400N Series Genset Controller
HGM400N Series Genset Controller User Manual
When the controller detects that the genset voltage has fallen below the
pre-set value, it will initiate a warning alarm and the corresponding alarm
information will be displayed on LCD.
When the controller detects that the genset frequency has exceeded the
pre-set value, it will initiate a warning alarm and the corresponding alarm
information will be displayed on LCD.
When the controller detects that the genset frequency has fallen below the
pre-set value, it will initiate a warning alarm and the corresponding alarm
information will be displayed on LCD.
When the controller detects that the fail to charge warning signals, it will
initiate a warning alarm and the corresponding alarm information will be
displayed on LCD.
If over power detection is enabled, when the controller detects that the
over power value (power is positive) has exceeded the pre-set value and
the action select "Warn", it will initiate a warning alarm.
2017-04-21 Version 1.2 Page 13 of 36