Connections - Smartgen HGM400N Series User Manual

6

CONNECTIONS

Compared with HGM420N, HGM410N has no Mains AC Voltage input terminals. The rear panel of
HGM420N is as below.
Description of terminal connections:
Pin Function
1 B-
2 B+
3 Aux. Output 1
4 Crank
5 Aux. Output 2
6 Aux. Output 3
7 Digital Input 1
8 Digital Input 2
9 Digital Input 3
10 Digital Input 4
HGM400N Series Genset Controller
HGM400N Series Genset Controller User Manual
Cable Size
2
2.5mm Connected with negative of starter battery.
DC power supply. Connected with positive of starter
2
2.5mm battery. If wire length is over 30m, better to double
wires in parallel. Max. 20A fuse is recommended.
B+ is supplied by 2 point, rated
2
1.5mm
5A.
Crank Relay Output; B+ is
2
1.5mm supplied by 2 point, rated 5A.
Connect to starter coil.
B+ is supplied by 2 point, rated
2
1.5mm
5A.
B+ is supplied by 2 point, rated
2
1.5mm
5A.
2
1.0mm Ground connected is active (B-)
2
1.0mm Ground connected is active (B-)
Ground connected is active (B-);
2
1.0mm
Can be used as Level Sensor.
Ground connected is active (B-);
2
1.0mm
Can be used as Config. Sensor.
2017-04-21
Description
See
Performance
and
Characteristics
See
Version 1.2 Page 16 of 36
7.3