Smartgen HGM400N Series User Manual page 17

Pin Function
11 Engine Temp. Sensor
12 Oil Press Sensor
13 Current IA
14 Current IB
15 Current IC
16 Current COM
17 Magnetic Pickup
18 Charger D+
19 Aux. Output 4
20 Aux. Output 5
21 Aux. Output COM
22 Gen AC Voltage U
23 Gen AC Voltage V
24 Gen AC Voltage W
25 Gen AC Voltage N2
26 Mains AC Voltage R
27 Mains AC Voltage S
28 Mains AC Voltage T
29 Mains AC Voltage N1
Note: USB interface is parameters programmable interface that can be programmed via PC.
HGM400N Series Genset Controller
HGM400N Series Genset Controller User Manual
Cable Size
Connect to temperature/cylinder
2
1.0mm
resistance sensor.
Connect
2
1.0mm
resistance sensor.
Outside connected to secondary coil of current
2
1.5mm
transformer(rated 5A)
Outside connected to secondary coil of current
2
1.5mm
transformer(rated 5A)
Outside connected to secondary coil of current
2
1.5mm
transformer(rated 5A)
2
1.5mm See INSTALLATION in this manual.
Connect to speed sensor;
2
0.5mm Shielded wire is recommended.
The other end of speed sensor connects to B-.
Connect to charging starter's D+ terminal. If there is
2
1.0mm
no this terminal, then be hang up.
The combination of terminal 19 and 21 is relay
2
1.0mm
normally open contact; rated 5A; Voltage free.
The combination of terminal 20 and 21 is relay
2
1.0mm
normally open contact; rated 5A; Voltage free.
2
1.5mm Common terminal of auxiliary output 4 and 5.
Connected to U-phase of generator (2A fuse is
2
1.0mm
recommended)
Connected to V-phase of generator (2A fuse is
2
1.0mm
recommended)
Connected to W-phase of generator (2A fuse is
2
1.0mm
recommended)
2
1.0mm Connected to N-wire of generator.
Connected to R-phase of mains (2A fuse is
2
1.0mm
recommended) (HGM410N without)
Connected to S-phase of mains (2A fuse is
2
1.0mm
recommended) (HGM410N without)
Connected to T-phase of mains (2A fuse is
2
1.0mm
recommended) (HGM410N without)
2
1.0mm Connected to N-wire of mains (HGM410N without)
2017-04-21
Description
to oil pressure
Version 1.2
See 7.4
Page 17 of 36