Smartgen HGM400N Series User Manual page 21

No Items
44 Aux. Output 3
45 Aux. Output 4
46 Aux. Output 5
47 Digital Input 1
48 Digital Input 1 Active
49 Digital Input 1 Delay
50 Digital Input 2
51 Digital Input 2 Active
52 Digital Input 2 Delay
53 Digital Input 3
54 Digital Input 3 Active
55 Digital Input 3 Delay
56 Digital Input 4
57 Digital Input 4 Active
58 Digital Input 4 Delay
59 Power On Mode
60 Module Address
61 Passwords
62 Crank Disconnect
Disconnect Magnetic
63
Pickup
64 Disconnect Gen Freq
65 Disconnect OP
High Temp.
66
Enabled
67 Low OP Inhibit Enabled
68 Low Fuel Level Inhibit
69 Config. Sensor Inhibit
HGM400N Series Genset Controller
Range
(0-17)
(0-17)
(0-17)
(0-15)
(0-1)
(0-20.0)s
(0-15)
(0-1)
(0-20.0)s
(0-15)
(0-1)
(0-20.0)s
(0-15)
(0-1)
(0-20.0)s
(0-2)
(1-254)
(0-9999)
(0-6)
(0-3000)r/min
(10.0-30.0)Hz
(0-400)kPa
Inhibit
(0-1)
(0-1)
(0-1)
(0-1)
HGM400N Series Genset Controller User Manual
Default
3 Factory default: Idle Control
5 Factory default: Close Generator
6 Factory default: Mains Closed
1 Factory default: High Temperature Input
0 Factory default: Close to active
2.0
Factory default: Low Oil Pressure Warning
2
Input
0 Factory default: Close to active
2.0
10 Factory default: Remote Start
0 Factory default: Close to active
2.0
11 Factory default: Fuel Level Warn
0 Factory default: Close to active
2.0
0: Stop Mode
0 1: Manual Mode
2: Auto Mode
1 Communication address of controller.
0318
There are 3 conditions of disconnecting starter
with engine: Generator Frequency, Magnetic
Pickup, Oil Pressure. Each condition can be
2
used alone and simultaneously to separating
the start motor and genset as soon as possible.
See 7.5
When engine speed higher than the set value,
360
starter will be disconnected.
When generator frequency higher than the set
14.0
value, starter will be disconnected.
When generator oil pressure higher than the set
200
value, starter will be disconnected.
Factory default: when high temperature occurs,
0
shutdown alarm is initiated. Note 2
Factory default: when low oil pressure occurs,
0
shutdown alarm is initiated. Note 3
Factory default: when low fuel level occurs,
1
shutdown alarm is initiated. Note 4
Factory default: when config. sensor value
higher/lower than the set value (particular case
1
depends on the sensor type), shutdown alarm
is initiated.
2017-04-21 Version 1.2
Description
Page 21 of 36