Coastcom D/I Mux III System User Manual page 224

Error
Message
Reinstall Line Power-up sequence of the line card is not
Card Error correct.
Switch to Normal Self explanatory.
Mode
That Slot Appears Operation cannot be performed because
Unoccupied there is no card in the slot, or because
that card is not responding.
This Selection Has Self explanatory.
No Meaning For
D4W Card
Two Alarm Map Self explanatory.
Types Not Allowed
Two Event Maps Only one event map can be enabled at a
Cannot Be time. When a second event map is
Enabled enabled, the first event map's status is
changed from Enabled to Disabled.
Two Time Maps Only one time map can be enabled at a
Cannot Be time. When a second map is enabled, the
Enabled first map's status is changed from Enabled
to Disabled.
Two Time Maps Self explanatory.
With The Same
Time Not Allowed
Try Again Self explanatory.
Unsupported Loop Self explanatory.
Code
Upper Strobe Card Self explanatory.
Not Installed
Upper Strobe Self explanatory.
Error
Working Map Type The map is currently the working map and
Cannot Be cannot be modified while it is the working
Modified map.
Chapter 5. Diagnostics
Cause
204
Solution
Install line card again, perhaps with power off.
Informational message only; no action required.
Check to see if a card is in the slot. Reseat the
card, then re-enter the command. If the message
continues to be received, replace the card.
Informational message for dual-four wire cards.
Make corrections and retry.
Informational message. Make corrections and
retry.
Informational message. Make corrections and
retry.
Informational message. Make corrections and
retry.
Informational message. Make corrections and
retry.
Informational message. Make corrections and
retry.
Informational message only; no action required.
Informational message only; no action required.
Check the upper strobe card and retry the
operation.
Select another map to modify, or make another
map the working map. When the map is no longer
the working map, its type can be changed.