Obtaining System Access - Coastcom D/I Mux III System User Manual

Obtaining System Access

The following procedure begins system configuration. After completing proper installation procedures,
and applying power to the D/I Mux III shelf, turn on the control terminal to commence system access.
The system will power up and, after a period of approximately 45 seconds, the password prompt
appears. At initial startup, it is not necessary to enter a password. Press [Enter]. To access the Main
Menu with a Common Control Unit (CCU), the screen in Figure 4-2 will appear. Type ? and press
[Enter].
18:19:13 11/01/95
Access Level is: 1
Alarm Reporting is :
Type ? for Help
]?
08:42:57--------------------------[ Menu ]--------------------------11/28/95
ALARMS
DA Display
ZA Clr Cnts SO
SHELF CONFIGURATION
DC Display
SC Set
MAP TABLE
DT Display DN
ST Edit SN
CLOCK SOURCE
DS Display SS
PASSWORDS
LO Logout SW
DW Display EW
To access the Main Menu with an Advanced Multiplexer Control Unit (AMCU), type ? and [Enter], and
the AMCU Main Menu will appear (depending upon the user password level), as shown in Figures 4-3, 4-
4 and 4-5. For more information, see the password command sections included later in this chapter.
Chapter 4. Configuration and Operation
1141 Harbor Bay Parkway
NO REPORTING
SYSTEM PARAMETERS
DP
Set Comm. Rpts SR
LINE CARDS
DL
CL
MAP MATRIX
Disp. Wrking DM
Set Wrking SM
DIAGNOSTICS
Set OL
PERFORMANCE
Install PM
Erase DH
Figure 4-2. CCU System Access Screen
Coastcom
Alameda, CA 94502
Display
Set Comm. Rate SP
Display Table DD
Copy Config SL
Display
Edit CM
Line Card OD
FDL Monitor SB
Alarm History ZH
105
Set
Disp Config
Set Config
Copy
T1-CSU
Set Error Rate
Clr Alm History