Configuring The Master In Profibus Network Configuration Tool; Assigning The Device To The Correct Hardware - Honeywell Experion PKS User Manual

6 PROTOCOL BLOCK

6.4 Configuring the master in Profibus Network Configuration Tool

While configuring the master, the mandatory task that you must perform is modifying the field network tag
name.
You can also perform the following tasks while configuring the master.
• Assign the device to the correct hardware.
• Change the PROFIBUS network setup values.
• Change the field network device address.
• Change the master settings.
Attention
To perform any of the above tasks, you must navigate to the Field Network Configuration tab of the Protocol Block
configuration form and double-click the master in the Network view.
Perform the following steps to configure the master
Click the Field Network Configuration tab of the Protocol Block configuration form.
1
Double-click the master in the Network view.
2
You can also right-click the master in the Network view and select Configuration.
The configuration window appears. The Device Assignment menu in the Navigation Area is selected by
default. The device assignment details appear in the right pane.
Perform the following as required.
3
• "Assigning the device to the correct hardware" on page 70
• "Modifying the PROFIBUS network setup values (bus parameters)" on page 71
• "Configuring the field network tag names" on page 72
• "Changing the field network device address " on page 76
• "Grouping adjacent modules into one logical module" on page 82
• "Changing the master settings" on page 76
• "About modifying the field network configuration during runtime" on page 86
4 Click OK.
5
Click Save
A message appears after you save the configuration.
6 Click OK.
7 Click OK to close the Field Network Configuration form.
The field network configuration is saved to the ERDB.

6.4.1 Assigning the device to the correct hardware

You must assign the device to the correct hardware to monitor the status of the field network and the devices
online.
70 www.honeywell.com
in the Field Network Configuration tab toolbar.
Attention
When you click Save , the configuration is saved temporarily.
Attention
If you click Cancel and close the configuration form, the configuration is not saved to the ERDB even if you have
clicked Save on the Field Network Configuration tab toolbar.