Viewing The Status Of All Slave Devices From The Profibus Network Configuration Tool Network View - Honeywell Experion PKS User Manual

Attention
You must right-click the master and select Disconnect to discontinue monitoring the master online.
3 Right-click the master and select Diagnostic.
The Diagnostics form appears. The General Diagnosis menu is selected by default. You can view the
general diagnostics such as device state, network state, configuration state, watchdog time, and error count.
Select the Master Diagnosis menu in the Navigation Area to view the master diagnostics. The Master
4
Diagnosis provides information such as on the slave device status, number of active slave devices, number
of configured slave devices, and number of slave devices that have diagnostics.
5 Similarly, you can select the appropriate diagnosis menus in the Navigation Area to view the appropriate
diagnostics.
6 Click OK.
6.11.2 Viewing the status of all slave devices from the Profibus Network Configuration Tool Network
view
Perform the following steps to view the status of all slave devices from the Profibus Network Configuration Tool
Network view
1 Click the Field Network Configuration tab of the Protocol Block in which you have configured the master
and the slave device.
Right-click the master and select Start Debug Mode.
2
The status of each device appears in the "Profibus Network Configuration Tool" Network view as displayed
in the following figure.
6 PROTOCOL BLOCK
95