6 PROTOCOL BLOCK
3
If you want to add a device to the network, select Add from the Action column.
•
If the device is already added to the network, the value Skip appears in the Action column.
•
If you want to replace a device with another device, select Replace in the Action column.
4
Click OK.
6.11.6 Viewing the slave device diagnosis
Perform the following steps to view the slave device diagnosis
1
Navigate to the Field Network Configuration tab of the Protocol Block in which you have configured the
slave device and the master.
Right-click the slave device and select Connect.
2
The slave device appears highlighted as displayed in the following figure.
100
www.honeywell.com
Attention
You must right-click the slave device and select Disconnect to discontinue monitoring of the slave devices online.