5 PROFIBUS GATEWAY MODULE (PGM) BLOCK
5.8 PGM block station displays
Related topics
"Detail displays and faceplate names" on page 50
"Calling up the displays" on page 50
"Detail display tabs" on page 51
"PGM group detail display, system status display, group trend display" on page 54
"PGM faceplates" on page 57
5.8.1 Detail displays and faceplate names
The following table lists the names of the details display and faceplate of the PGM (primary/non-redundant and
secondary/redundant) block.
Tab Name
Primary or non-redundant
Main tab
Redundancy tab
Soft Failures tab
Configuration Details tab
Secondary or redundant
Main tab
Redundancy tab
Soft Failures tab
Configuration Details tab
5.8.2 Calling up the displays
The following table lists the actions that you must perform to call up the PGM block detail displays.
To call the PGM block...
Main tab display
Redundancy tab display
Soft Failures tab display
Config details display
Secondary PGM Main tab displays
Secondary PGM Redundancy tab
display
50
www.honeywell.com
Detail Display
sysdtlPGM2a.htm
sysdtlPGM2b.htm
sysdtlPGM2c.htm
sysdtlPGM2d.htm
sysdtlPGM2a.htm
sysdtlPGM2b.htm
sysdtlPGM2c.htm
sysdtlPGM2d.htm
Then ...
Type the point name (for example PGM2_325) in the Station command zone and
press F12.
You can also click the Search
name and click OK.
Click the Redundancy tab.
Click the Soft Failures tab.
Click the Config Details tab.
Click the
icon in the Station toolbar.
You can also type the point name (for example PGM2_325SEC) in the Station
command zone and press F12.
Click the Redundancy tab.
Faceplate
sysdtlPGM2a_fp.htm
sysdtlPGM2a_fp.htm
icon in the Station toolbar and type the point