Honeywell Experion PKS User Manual page 73

Attention
• You can also configure net tag names through Bulk Build operation. To do so, you must configure the
NETTAGPDCNAME and the NETTAGNAME parameters. The NETTAGPDCNAME contains the net tags for
the slave devices configured in "Profibus Network Configuration Tool". This parameter contains net tags starting
from index 1 (NETTAGPDCNAME[1]) in the Bulk Build XLS file. If you do not configure this parameter,
NETTAGNAMEs for the PDCs are not assigned in the DSB on creating and assigning it to the Protocol Block
through the Bulk Build tool.
• You cannot configure NETTAGPDCNAME[0] since element at index 0 is always empty and is used for
deselecting the configured NETTAGNAMEs in the PDC tab of the DSB. If you try to do so, an error message
appears.
• Whenever you reconfigure net tags for a PDC, you must reload the DSB before removing the same net tag in
Sycon and reloading the Protocol Block. This prevents the DSB or the PDC from going into error state during run
time while modifying the net tag usage.
1 Click the Process Data menu in the Navigation Area.
The slave devices that you have selected appear in the right pane.
2
Click to view the input and output modules associated with the specific device.
By default, the field network tags appear as Input_* or Output_* depending on whether the device is an
input module or an output module.
Select the field network tag in the Tag column and modify the tag name. If you do not modify the default
3
network tags, only the first default name for each input/output is used.
The following figure displays a sample Address Management page that replaces the Process Data page
and the Address Table pagein Experion R410.2 and later.
6 PROTOCOL BLOCK
73