Configuration Pc Preparation; 1: Install The Nfn Config Tool On The Configuration Pc; 2: Connect The Configuration Pc To The Nfn Gateway - Honeywell NOTIFIER ONYXWorks NFN Gateway Installation & Operation Manual

NFN Gateway Configuration

3.2 Configuration PC Preparation

NOTE: You must have completed the installation of the NFN Gateway before you proceed with
this preparation (refer to
A Configuration PC is defined as a PC that has the NFN Config Tool installed on it and it is able to
establish an IP connection with the NFN Gateway.
3.2.1 Install the NFN Config Tool on the Configuration PC
You need to install the entire ONYXWorks
PC (90 MB disk space). The CD-ROM automatically starts if your Configuration PC is setup to
start CD-ROMs automatically.
3.2.2 Connect the Configuration PC to the NFN Gateway
Use one of the following methods to connect the Configuration PC to the NFN Gateway.
• If the Configuration PC is on your IP network then you already have connected it to the NFN
Gateway if you performed the
Therefore you need to
page
• If you are going to use a PC and directly connect it to the gateway then you need to perform a
"Direct Connection to the Gateway PC Board" on page
NOTE: A direct connection requires that a cross over Ethernet cable to be made or purchased
by the customer.
30
"NFN Gateway Embedded Installation" on page
"IP Cable Connections" on page
"Add the IP Subnet of the NFN Gateway into the Configuration PC" on
32.
NFN Gateway Installation & Operation Manual - P/N: 52306:Rev: D 06/01/07
®
Workstation software application on the Configuration
24.
31.
Configuration PC Preparation
17).