System Operation; Key/Touchscreen Operation; Panic Key/Icons; Security Codes - Honeywell Lyric LCP300-L Installation And Reference Manual

System Operation

Key/Touchscreen Operation

Touchscreen icons displayed on the Smart Device allow the user to arm and disarm the system, and perform
other system functions, such as bypassing zones. Zone and system conditions (alarm, trouble, bypass) are
displayed on the LCD. When an alarm occurs, the Gateway and Smart Device (if installed) will sound, and the
zone(s) in alarm will be displayed. Pressing any key will silence the keypad sounder for 10 seconds (only once).
Disarming the system will silence both console and external sounders. When the system is disarmed, any zones
that were in an alarm condition during the armed period will be displayed (memory of alarm). To clear this
display, simply repeat the disarm sequence by selecting "Disarmed" and entering the Security Code. The
console also features chime annunciation, and three panic key icons for silent, audible, Fire or Medical
emergency alarms. These keys can notify the Central Station of an alarm condition, if that service is connected.

Panic Key/Icons

There are three panic keys that are active (if programmed) when the "Emergency" or any of the keys is selected
for approximately five seconds.
The keys can be used to manually initiate alarms and send a report to the Central Station. Each can be
individually programmed for 24-hour silent, audible, personal or fire emergency responses. The panic function is
activated when the respective keys is pressed. The panic functions are identified by the system as follows:
Zone Function
995 Fire Emergency
996 Medical Emergency
998 Local Alarm
999 Police Emergency
Important: For the silent panic functions to be of practical value, the system must be connected to a Central
Station.

Security Codes

Installer Code

The installer programs the 4-digit Installer Code initially as part of the programming procedure. The
factory default Installer Code is 4-1-1-2, but may be changed in the Installer Code programming field.
The Installer Code is the only code that allows entry into Installer Programming mode.

Master Code

In normal operation mode, the Master (Security) Code is used to enter the 4-digit User Security Codes and enter
the Master User Tools Menu mode.

Enter/Change the Master Code by Installer.

The factory default Master Code for the Lyric Gateway is set to 1-2-3-4. The Master Code is used to enter the 4-
digit User Security Codes.
SCREEN

Secondary User Codes

In normal operation mode, the Master (Security) Code can be used to assign up to 46 secondary 4-digit security
codes, including a Guest Code and a Duress Code. The Master Code can also be used to individually remove
secondary codes from the system. Refer to the Lyric Gateway User Manual for additional information.
The panic key screen will timeout if a selection is not made within ten seconds.
1. After entering the Master User Menu screen, select the "Users"
icon. The system displays the User Code Programming screen.
2. Select "Master", then select "Edit".
3. Enter a new 4-digit Master (Security) Code on the displayed
keypad. The system displays the new code on the left side of the
screen.
4. Select "Done" when you are finished.
5. The system returns to the Master Code Programming screen.
- 21 -
Lyric Controller Installation and Reference Guide
ACTION