Panasonic FP7 User Manual page 75

 Details of setting parameters
Setting
Settings
item
Control
S1
target
Control
S2
content
 Precautions during programming
• When specifying a device for an operand in which character constant can be specified, set
string data beforehand with SSET instruction.
• When specifying string data, the number of characters should not execeed 256.
• Upper and lower case characters can be used for operands which character constant can be
specified.
("Abcd", "ABCD" and "abcd" are synonymous, however, the file names are differentiated.)
• A target unit for the instruction is specified with UNITSEL beforehand.
• This instruction is not available in interrupt programs.
 Operation of FTPc control relay
Name
Transfer cancel relay
Transfer disable relay
Transfer request
Transfer active
Transfer retry active
Transfer done
Transfer failed
Transfer direction
(Note): The state of control relays can be read with ETSTAT instruction.
Setting example
Settings
Example When enabling the
1 transfer of transfer No. 5
Example When disabling all
2 transfers
Example When canceling the
3 transfer of LOG7
1) When specifying transfer numbers
individually
2) When specifying LOG numbers
individually
3) When specifying all transfer numbers
and LOG numbers
1) When enabling transfer
2) When disabling transfer
3) When cancelling transfer
Transfer enabled
Not change
OFF
Not change
Not change
Not change
Not change
Not change
Not change
S1
"ID5"
"ALL"
"LOG7"
4.4 How to Use File Transfer
Specify 0 to 15 for x with "IDx".
Specify 0 to 15 for x with "LOGx".
Specify "ALL".
Specify "ENABLE".
Specify "DISABLE".
Specify "CANCEL".
Transfer disabled
Not change
ON
Not change
Not change
Not change
Not change
Not change
Not change
S2
"ENABLE"
"DISABLE"
"CANCEL"
Transfer canceled
ON
Not change
Not change
Not change
Not change
Not change
Not change
Not change
4-43