Panasonic FP7 User Manual page 63

 Precautions during programming
• When specifying a device for an operand in which character constant can be specified, set
string data beforehand with SSET instruction.
• When specifying string data, the number of characters should not execeed 256.
• Upper and lower case characters can be used for operands which character constant can be
specified.
("Abcd", "ABCD" and "abcd" are synonymous, however, the file names are differentiated.)
• A target unit for the instruction is specified with UNITSEL beforehand.
• This instruction is not available in interrupt programs.
 Operand [S1] setting
• Specify the starting address storing the transfer setting number or a character constant.
Setting
Settings
item
S1 Transfer setting No.
(Note): Transfer setting numbers should be specified from number 0 in ascending order. An error occurs when
transfer setting numbers are not specified in ascending order. If transfer settings have been already registered,
this rule is not applied.
Setting example
Example 1 S1
Settings
Example 2 S1
Settings
Specify a transfer setting number. ID=: Transfer setting
number
"ID=1"
Transfer setting number: 1
"ID=8"
Transfer setting number: 8
4.4 How to Use File Transfer
Setting
range
0 to 15
4-31