Panasonic FP7 User Manual page 124

HTTP Client Function
• A target unit for the instruction is specified with UNITSEL beforehand.
• This instruction is not available in interrupt programs.
 Details of setting parameters
Setting
Settings
item
S1 Control target
Control
S2
content
Setting example
Settings
When enabling the
Example
transfer of transfer No.
1
5
Example When disabling all
2 transfers
Example When canceling the
3 transfer of ID7
When enabling the
Example
transfer of transfer No.
4
10 (Note)
(Note): For specifying a device for an operand which can specify character constants, store string data with SSET
instruction excluding a double quotation mark.
 HTTPc control relay flag operation
Name
Transfer cancel relay
Transfer disable relay
Transfer request
Transfer active
Transfer retry active
Transfer done
Transfer failed
Transfer direction
5-28
1) When specifying transfer
numbers individually
2) When specifying all transfer
numbers
1) When enabling transfer
2) When prohibiting transfer
3) When cancelling transfer
S1
"ID5"
"ALL"
"ID7"
DT0
Value
DT0 4 (No. of
characters)
DT1 H44(D)
DT2 H30(0)
DT3
Transfer enabled
Not change
OFF
Not change
Not change
Not change
Not change
Not change
Not change
Specify 0 to 15 for x with "IDx".
Specify "ALL".
Specify "ENABLE".
Specify "DISABLE".
Specify "CANCEL".
S2
"ENABLE"
"DISABLE"
"CANCEL"
DT10
DT10
H49(I) DT11
H31(1) DT12
DT13
DT14
Transfer disabled
Not change
ON
Not change
Not change
Not change
Not change
Not change
Not change
Value
6 (No. of
characters)
H4E(N) H45(E)
H42(B) H41(A)
H45(E) H4C(L)
Transfer canceled
ON
Not change
Not change
Not change
Not change
Not change
Not change
Not change