Panasonic FP7 User Manual page 183

 Precautions during programming
• When specifying a device for an operand in which character constant can be specified, set
string data beforehand with SSET instruction.
• When specifying string data, the number of characters should not execeed 256.
• Upper and lower case characters can be used for operands which character constant can be
specified.
("Abcd", "ABCD" and "abcd" are synonymous, however, the file names are differentiated.)
• A target unit for the instruction is specified with UNITSEL beforehand.
 Operand [S1] setting
Setting
Settings
item
Control
S1
target
 Operand [S2] setting
Setting
Settings
item
Control
S2
content
 Mail send control relay flag operation
Name
Send cancel relay
Send disable relay
Send request
Send active
Send retry active
Send done
Send failed
Send direction
(Note): The send cancel relay turns OFF when the SMTPc transfer request instruction is executed.
1) When specifying send numbers
individually
2) When specifying LOG numbers
individually
3) When specifying all send numbers and
LOG numbers
1) When enabling sending
2) When disabling sending
3) When cancelling sending
Transfer enabled
Not change
OFF
Not change
Not change
Not change
Not change
Not change
Not change
6.3 How to Use Event Mail Transmission
Specify 0 to 15 for x with "IDx".
Specify 0 to 15 for x with "LOGx".
Specify "ALL".
Specify "ENABLE".
Specify "DISABLE".
Specify "CANCEL".
Transfer disabled
Not change
ON
Not change
Not change
Not change
Not change
Not change
Not change
Transfer canceled
ON
Not change
Not change
Not change
Not change
Not change
Not change
Not change
6-55