Basic Procedures For Stimulation And Lesion - NeuroTherm NT1100 Operator's Manual

Basic Procedures for Stimulation and Lesion

10.3.1 Auto Test Procedure – Basic Check
1) The Mains Power switch is OFF (Located at the rear of the generator)
2) Connect the Mains Power Lead to the machine
3) Switch the mains power ON (The Mains light will illuminate Green)
4) The Unit will carry out an auto test (If all procedure functions are operating the display will
change to the Welcome Screen)
5) From the Welcome Screen the user can continue to use the system using the default
settings or optimising the settings to their requirements.
6) For a standard default procedure the electrode would be a single electrode in socket 1.
7) To use the basic default settings follow the "Seven Steps Procedure"
10.3.2 Seven Steps Stimulation and Lesion Procedure
Step 1 Switch on power to the NT1100 (wait for self test)
Step 2 "Accept" Default Profile (ensure the settings are correct for the procedure)
Step 3 "Accept" procedure settings
The control of the procedure is now transferred to the active panel with the touch screen
being disabled.
Step 4 Perform "Sensory" stimulation
Step 5 Select "Motor" Stimulation and perform Stimulation
Step 6 Select "Lesion" and press "Auto-Start"
Step 7 After completion of lesion, select "End Session"
The Procedure is now completed and a record has been saved
Document 109.00
NEUROTHERM RADIO FREQUENCY LESION GENERATOR
OPERATORS MANUAL
®
MODEL NT1100
10September2012 Issue 06
10-17