Setting Up The Machine For The First Time - NeuroTherm NT1100 Operator's Manual

Users can set up the parameters for each sub menu in any order. At any stage if 'Accept' is
pressed, settings will be stored, and the user will return to the previous screen they were viewing.
(Instructions for more Advanced Use Custom Profiles and using multiple probes) are detailed
in Section 7

Setting up the machine for the first time

1. Turn the NT1100 on using the power switch on the rear of the unit
2. The machine will boot, to the self- test screen, where all of the hardware is initialised and
diagnostic tests are performed.
3. The NT1100 will then show the following screen:
4. The date and time should then be set up. Using the touch screen, select 'options' to show
the "File Control" screen then select "More..."to show the "Machine Control" screen.
Select the "Date / Time" button
The options screen will then show. To set the date, use the up and down arrows next to 'Date
Set' (DD/MM/YYYY format) The time is set in a similar way, by using the up and down arrows
next to 'Time Set' (HH:MM format). The time format is a 24 Hour clock. Once completed
press 'Accept' and the "Finish" button twice to return to the welcome screen.
Document 109.00
NEUROTHERM RADIO FREQUENCY LESION GENERATOR
MODEL NT1100
OPERATORS MANUAL
®
10September2012 Issue 06
6-8