Connector Panel Layout - NeuroTherm NT1100 Operator's Manual

Connector Panel Layout

Dispersive Socket
This 4mm socket is for the lead of the Dispersive Patient Plate which should be at least 135 sq cm
(21 square inches)
Test Socket
This 2mm socket is used to connect the Test Block for use in testing the thermocouple probes in
the Stimulate Mode
Probe Socket No1
This 4 pin socket is used to connect single electrodes for standard RF Lesion and Pulsed RF
Lesion Procedures
Probe Socket No2
This 4 pin Socket is used to connect electrodes used for 'special' procedures for example
Cordotomy.
Probe Socket No3
This 4 pin socket is used to connect electrodes used for 'special' procedures.
[Special procedures include two and three electrode procedures, dual electrode procedures,
bipolar electrode and Cordotomy procedures]
Document 109.00
NEUROTHERM RADIO FREQUENCY LESION GENERATOR
OPERATORS MANUAL
®
MODEL NT1100
10September2012 Issue 06
5-6