NeuroTherm NT1100 Operator's Manual page 69

Level 1 - User Advice
Message Scenario
When setting defaults in Doctor setup screen
When the user presses the log button
Impedance goes open circuit when the output is
switched off
In motor or sensory stimulation setup screen,
when a voltage is selected in the sensory
stimulation setup
In motor stimulation or sensory setup screen,
when a current is selected in the sensory
stimulation setup
In pulsed dose procedure screen
In Pulsed Dose/Pulse RF procedure screen,
before the procedure is actually started.
In pulsed RF/Pulse Dose setup screen, when a
temperature higher than 45 degrees is selected
In Pulsed RF/Pulse Dose setup screen, when a
voltage higher than 45 volts is selected
In custom step lesion setup screen
When the auto start function is used to switch on
the lesion power
This message will stay there until the timer runs
out
When the lesion power is started manually
This message will stay there until the timer runs
out
Impedance of 2000 ohms or more with the output
switched off
Impedance of less than 50 ohms with the output
switched off
When timer runs out and the power was switched
on manually
When the accept button is pressed in the setup
confirmation screen with any mode selected, but
there is no probe or a faulty probe connected to
socket 1
When the accept button is pressed in the setup
confirmation screen with any mode selected, but
there is no probe or a faulty probe connected to
socket 2
Document 109.00
NEUROTHERM RADIO FREQUENCY LESION GENERATOR
MODEL NT1100
OPERATORS MANUAL
®
Message Text
These setting will be saved as defaults
Marker added to log file
Impedance open circuit - check continuity of circuit
Stimulation set to constant voltage
Stimulation set to constant current
Estimated time left: mm:ss
For Pulsed RF/Pulsed Dose press 'Pulse' Button
Selected temperature above 45 degrees
Voltage above 45 V
Procedure time: mm:ss
Lesion power automatic mode
Lesion power manual mode
High Impedance - check probe and leads
Low impedance - check probe and leads
End of time - Switch off RF power control
No probe detected
Output 1
No probe detected
Output 2
10September2012 Issue 06
8-2
Message
code
1-001
1-002
1-003
1-004
1-005
1-006
1-007
1-009
1-010
1-011
1-013
1-014
1-033
1-015
1-017
1-018
1-019